CCNA1-ITNv7-H10

• ICT
• MBO
• Studiejaar 1

CCNA1 - ITNv7

Module 10: Basic Router Configuration

What command is used to switch to privileged EXEC mode?

1. enable
2. configure terminal
3. exec mode
4. elevate

What command is used to encrypt all passwords in the running-config?

1. enable secret password
2. enable password password
3. service password-encryption
4. encrypt passwords

What will the prompt show after the command "hostname R1"?

1. R1>
2. R1#
3. R1(config)#
4. R1(privileged)>

What command is used
to start configuring the SVI?

1. enable secret password
2. enable secure svi
3. line vty 0 4
4. configure line svi

What is the result of the command
"no shutdown"

1. the interface will not shut down on errors
2. the interface will be activated
3. the interface will stop processing frames
4. the interface will be closed to any traffic

What does "brief" mean?

1. short
2. letter
3. all
4. configured

What command is used to show all IPv6 addresses configured?

1. show all ipv6 addresses
2. show ip interface brief
3. show ipv6 interface brief
4. show address ipv6

What number is shown after
"enable secret" in the running-config?

Which two characters are show after "banner motd" in the running-config?

What password hash is shown in the "line con 0" section of the running-config?
(the hash is shown behind "password 7")

What is the first "C" network
shown in the IPv4 routing table on R1?

What is the second "C" network
shown in the IPv4 routing table on R1?

What is the first "C" network
shown in the IPv6 routing table on R1?

What is the last "L" address
in the IPv6 routing table on R1?

What command is used to switch to privileged EXEC mode?

1. enable
2. configure terminal
3. exec mode
4. elevate

What command is used to encrypt all passwords in the running-config?

1. enable secret password
2. enable password password
3. service password-encryption
4. encrypt passwords

What will the prompt show after the command "hostname R1"?

1. R1>
2. R1#
3. R1(config)#
4. R1(privileged)>

What command is used
to start configuring the SVI?

1. enable secret password
2. enable secure svi
3. line vty 0 4
4. configure line svi

What is the result of the command
"no shutdown"

1. the interface will not shut down on errors
2. the interface will be activated
3. the interface will stop processing frames
4. the interface will be closed to any traffic

What does "brief" mean?

1. short
2. letter
3. all
4. configured

What command is used to show all IPv6 addresses configured?

1. show all ipv6 addresses
2. show ip interface brief
3. show ipv6 interface brief
4. show address ipv6

THANK YOU!